Solution Finder Get Tech Support

Level mode Switch on drivers SCALE™-2+ 2SC0115T2A0-12, 2SC0115T2A0C-12

Posted by: a.b.endoks on

Hello,

It is stated that multilevel or 2 level mode is available for SCALE™-2+ 2SC0115T2A0-12, 2SC0115T2A0C-12 drivers. But when I checked the manual and datasheets, I could not see how to switch between these modes. There seems to be no pin or switches information on this. Could you help me figure out how it is adjusted?

Thanks.

Comments

Submitted by PI-IWH on 04/28/2022

Dear

Could you please show here where you find this statement, which will be helpful for us to do precise support

the purpose is to understand your question clearly first before we provide any answer.

thanks

Submitted by a.b.endoks on 06/13/2022

I have sent images in attachments that shows this driver can be used on 3 Level NPC topologies but I could not see any mode switches on schematics or anywhere else. I could not figure out how it is adjusted to 2 Level or 3 Level modes.

Attachment Size
2SC0115T_1.png 53.38 KB
2SC0115T_2.png 80.58 KB
Submitted by PI-IWH on 06/14/2022

Dear 

2SC0115T2A0-xx is a two gate channel driver solution , whose target is a half-bridge basic topology.

you can use this two channel solution to driver your NPC topology as well in a system level.

the point is that the we have customers is using 2SC0115T2A0-xx to build their NPC system , the driver has corresponding figures to make sure the system running in a protected way